Varimixer W20 F Instruções de Operação descarregar pdf (Página 6)

(45) Bowl arms are to be exchanged in the following way:

a) Disconnect the mixer on the main switch or disconnect the connecting cable.

b) Lower the bowl arms.

c) Put the mixer down on its back and take off the legs of the mixer (17) by removing the screws (18).

d) The bottom plate (19) is taken off by removing the nuts (20).

e) Take out the cutter pin (51) securing the lifting bolt (46) and the lifting nut (47).

f) Take out the lifting bolt (46) and the lifting nut (47).

g) The 2 circlips (48) are removed from the 2 bowl arm guide rods (49) whereafter the bowl arm guide rods (49)

can be knocked back so that the bowl arms are free and can be taken out.

(50) The lifting lever is exchanged in the following way:

a) Start as described above from a) to f) incl.

g) The crank shaft (52) is taken off by removing the circlip (56).

h) Ensure that the key (53) has been removed, too.

i) The lifting lever (50) can now be taken out.

(58) Safety switch for bowl lift (58) must be adjusted

in a way that it will not be activated when the bowl is in working position.

ADJUSTING OF BOWL HEIGHT:

a) Lower the bowl arms.

b) The counter nut (54) is loosened and the cutter pin (51) is taken out.

c) Take out the lifting bolt (46) with the lifting nut (47).

d) The bowl height is now adjusted by turning the lifting nut (47) either out or in, on the lifting bolt (46).

e) Mount the lifting bolt with the lifting nut and the cutter pin, and tighten the counter nut (54).

f) Ensure that the measure (D) = 127,5 mm is correct when the bowl is raised to normal working position, and

repeat the procedure if the measure is not correct.

g) Ensure that all mixing tools are fitting in the bowl.

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Varimixer W20 F Instruções de Operação Página 6